What 82 owners told NHTSA about the 2021 Mercedes-benz Gle-class Hybrid

The vehicle has repeatedly experienced a sudden loss of acceleration, entering a reduced-power state while driving. Most recently, this occurred less than one week after I was advised that the issue had been fully resolved through a relay replacement. Critically, these incidents have occurred while my [XXX] child was in the vehicle, creating an unsafe and unacceptable situation. Below is a summary of the work that was done to resolve the safety concern. October: Drivetrain/Powertrain control unit internal fault Replacement of gateway/powertrain control module Wiring, grounding, and software inspections November: Active Brake Assist, ESP, and voltage supply faults Failure of both rear wheel speed sensors Replacement of left and right rear wheel speed sensors December: Dealership identified a faulty relay as the root cause Relay replaced and vehicle returned to service January, the vehicle again lost acceleration. And now, again in February. The same loss in acceleration incident. At this point, the vehicle has demonstrated a pattern of unresolved, safety-critical electrical failures. Given the repeated nature of the issue, the prior replacement of major components, and the involvement of braking and drivetrain systems, I no longer feel confident that additional part replacement without corporate oversight will result in a safe or permanent resolution. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ODI 11718456

Purchased as a CPO directly from a local dealership. Vehicle has experienced multiple (10+), seemingly random failures of the Electronic Stability Control, Blind Spot Assist, Lane Keeping Assist and Active Break Assist under varied driving and weather conditions. On two separate occasions (one at 15+ mph and the other at 65+), these system failures were accompanied by a brief "limp mode" and immediate total loss of acceleration. The most recent loss-of-acceleration event occurred during lunch hour traffic on the highway, at highway speeds. The vehicle has been taken to the dealership to address these issues on 3 separate occasions. Visit #1: the communication fault codes were noted by the technicians, but they could not replicate the issues. The faults were cleared and the vehicle service was deemed complete. Visit #2 (3 days later and the first instance of acceleration loss): report from service department reads almost identical to that of Visit #1 except the notation that "...found several stored faults for communication with engine control unit." Again, the issues could not be replicated and the faults were cleared. Viewed as an unacceptable response by the consumer, the dealership retained the vehicle for further troubleshooting with the follow-on report noting, "Found no socket tension at Sockets 27 and 28 to PTCU. Removed and replaced sockets 27 and 28 at ME connector 6." The faults were, again, cleared and the vehicle was returned to the owner. Visit #3 (roughly 5 weeks after last visit and the second instance of acceleration loss, this time on the highway): The same complement of warning lamps illuminated, the car lurched, and there was zero acceleration. The vehicle was navigated to the highway's shoulder without incident and shut down. After 5+ minutes, the vehicle was restarted and acceleration functioning had returned. It was immediately driven to the dealership where it currently awaits repair.

NHTSA ODI 11539114

Driving down a multi-lane highway at 70 mph, a 48V battery malfunction warning goes off as well as the yellow check engine light. A few seconds later a ‘coolant’ error alert pops up. SUV loses acceleration with power dropping from 70 mph to 55 mph to 35 mph. Another message displayed on screen warning me to “Pull over and turn the engine off.” Narrowly missing being hit from the back, I was able to coast to an upcoming exit into a store’s parking lot before the car stalled completely.

NHTSA ODI 11536714

Issue-The car brakes aggressively using cruise control (Mercedes Distronic) with no driver intervention. This dangerous condition can cause an accident. Using my advanced cruise control…the issue is my set speed was changed along with acceleration or braking when a traffic sign is misread. I have turned off the only setting controls Traffic Sign Assist & Route Based Speed Assist but there is no change. Example of issue-My car was misreading 80mph as 60 & braking aggressively. .My prior 2020 GLE misread signs less often and did not change the speed setting or brake the vehicle. The Dealer applied all available software updates. After all the updates my car continues to adjust set speed to every misread traffic sign. For example recently I had my speed set at the posted speed of 80 and the car read a sign as 70, changed the 80 to 70, and started braking aggressively. In Idaho there are stacked signs-the upper one reads 80 and below “Trucks 70” so this happens about 50% of the time. The vehicle misreads signs often.

NHTSA ODI 11436351