Engine surge while braking. New 2025 Jeep Wrangler Rubicon with 450 miles. V-6 engine and 8-speed automatic transmission. No modifications. Autonomous braking. Came to a traffic circle with yield sign. Slowed by braking for vehicle on right to enter traffic circle. The engine suddenly surged, began bucking as I depressed the brake further, and entered the traffic circle, just barely missing the vehicle to the right. One wheel (not sure which) began skidding as if the ABS had come one. I pulled over, shut the Jeep down and restarted. Problem did not recur. I tested pushing the brake while using the accelerator and the brake easily held the vehicle in stop. I am certain I did not "accidentally step on both the accelerator and brake at the same time." An hour later I took the vehicle into the Service Department of the local Jeep dealer. They did not run a diagnostic but said that there were various possible caused but had not seen it on Jeeps they had serviced. I looked on the various Jeep chatrooms on line and discovered that many people had had the identical problem over the last 5 years. Some say they reported it to NHTSA. This is likely a software or computer issue and is extremely dangerous. It needs to be addressed by the manufacturer It was only by sheer luck I did not hit the right-of-way vehicle Thank you for your interest.
NHTSA ODI 11684170