What 20 owners told NHTSA about the 2020 Mercedes-benz E-class Wagon

The Engine Electrical harness is completely corroded after only 50,000 miles requiring a 4k+ repair. Oil leaking from the camshaft sensor pushed it way all throughout harness. There are no warnings as it will only be noticeable after doing routine maintenance OUTSIDE of the manufactures warranty. While driving you may lose complete power or slight power loss due to engine misfiring and low system voltage. Warranty company has denied my claim saying that it looks as if the car was in an accident with water damage but the car is pristine and accident free. This is happening to all Mercedes with magnetic camshaft solenoids after doing routine spark plugs. Any movement of the wires will cause damage to the corrosion and then electrical problems. This happened before with previous generations and they recalled the engine to put extensions between the sensors and harness. Unfortunately they did not do a recall for this generation even though the same problem is apparent!

NHTSA ODI 11672020

The contact owns a 2020 Mercedes-Benz E350. The contact stated while his wife was driving and stopped at a traffic signal, the gasoline saving START/STOP feature turned off the vehicle however, upon depressing the accelerator pedal, the vehicle failed to restart. The contact stated that the failure caused the vehicle to roll into the intersection at approximately 3 MPH. The contact's wife was able to stop the vehicle and shift into park(P). The contact stated that his wife was able to restart the vehicle. The contact stated no warning light was illuminated. The contact stated that the failure had occurred twice. The contact had taken the vehicle to a local dealer, where it was diagnosed and determined that several software updates needed to be performed, and the updates were completed. The vehicle was repaired. The manufacturer was informed of the failure. The failure mileage was 47,726.

NHTSA ODI 11561351