What 245 owners told NHTSA about the 2022 Ford Explorer Gas

The contact owns a 2022 Ford Explorer. The contact stated that while the vehicle was in reverse, the rearview camera displayed a blank blue screen. The contact received notification of NTHSA Campaign Number: 26V123000 (BACK OVER PREVENTION); which was associated with the failure. However, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was 6,000.

NHTSA ODI 11750674

While driving, parking, or doing any function of the vehicle, the screen will intermittently switch from the cameras being used to the on board navigation and start routing the vehicle to random locations, or it may blank out completely. It has also frozen in place and will not display reverse cameras, show proximity sensors, or anything.

NHTSA ODI 11747294

We purchased our 2022 Ford Explorer brand new on April 12, 2022. The backup camera was nonfunctional that same evening. We brought the car to Porter Ford, where the issue was confirmed via diagnostic code U0264:00 ("Lost Communication With Camera Module Rear"). The dealership informed us that this was tied to a known recall, but that the necessary parts were unavailable. We waited more than two years for a resolution, during which time the camera system remained inoperable or intermittently failed. This defect directly impacts rear visibility, which is required under FMVSS 111. In August 2024, Willis Ford performed Recall 23S23, replacing the rear camera and wiring harness. The issue continued. In May 2024, they opened Recall 23S232, again noting a need for parts. In September 2024, the camera was replaced again. The issue persisted. In June 2025, the issue was finally diagnosed as a failed IPMB module and possibly a harness fault. Ford has since quoted us $2,937.90 to repair the issue—despite written confirmation from the service advisor to Ford that: "If the vehicle was still under warranty, this repair would be covered." We have not paid anything, and are refusing partial coverage, as the defect was: Reported within 24 hours of vehicle delivery Tied to multiple recalls Never resolved after years of authorized service center attempts This is a clear and ongoing safety defect affecting rear visibility. Ford has failed to comply with safety standards by not resolving the issue in a timely or effective manner. We request NHTSA investigation into Ford’s handling of this camera recall and similar issues in other 2022 Explorers.

NHTSA ODI 11698560

The contact owns a 2022 Ford Explorer. The contact stated that while the vehicle was parked, the rearview became inoperable. The contact stated that the rearview camera image was blank. The vehicle was taken to the dealer, where it was diagnosed that the processing module console had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure and referred the contact to the NHTSA Hotline for assistance. The approximate failure mileage was 76,000.

NHTSA ODI 11676271

The rear traffic warning did not alert timely, resulting in a fender bender in a parking lot. I have dash cam footage with audio supporting that it did not beep until it was too late.

NHTSA ODI 11671386

On my 2022 it’s has a warning that it has a faulty park aid faults

NHTSA ODI 11664147

The backup camera and related system on the 2022 Ford Explorer ST has malfunctioned and failed to show any images. I'd had the vehicle to the dealer on 3 occasions, whereby I've just learned the issue was improperly diagnosed by another dealer as a faulty camera, but the real problem of a faulty processor was diagnosed and therefore not replaced. This issue puts me, other vehicles and pedestrians in particular risk as there is not rear camera image being projected. The problem has been confirmed by two dealers, diagnosed and now indication is to repair it. This is clearly part of the broader issues Ford is having with rear camera back-up systems.

NHTSA ODI 11653910

When the car is put into reverse. The reverse camera display is delayed in showing or shows a blue screen in lieu of the rear view. It started to happen around the 26 or 28,000 mile mark.

NHTSA ODI 11616528

The contact owns a 2022 Ford Explorer. The contact received notification of NHTSA Campaign Number: 23V342000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that while attempting to use the rear-view camera, a blue screen was displayed. The contact stated there was message on the instrument panel that the rear camera failed to operate as intended. The dealer was made aware of the failure but confirmed that parts were not yet available. The vehicle was not repaired. The manufacturer was made aware of the failure and informed the contact that parts were limited. The failure mileage was approximately 24,000. Parts distribution disconnect.

NHTSA ODI 11592614

The contact owns a 2022 Ford Explorer. The contact received notification of NHTSA Campaign Number: 23V342000 (Back Over Prevention) however, the part to do the recall repair was unavailable. The local dealer was contacted, and it was confirmed that the part was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated that the backup camera displayed a blue screen. The vehicle was not repaired. The failure mileage was 45,000. VIN tool confirms parts not available.

NHTSA ODI 11559879

The contact owns a 2022 Ford Explorer. The contact received notification of NHTSA Campaign Number: 23V342000 (Back Over Prevention) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated that the image on the sync screen was blue. The failure mileage was 14,000. VIN tool confirms parts not available.

NHTSA ODI 11555228

The contact owns a 2022 Ford Explorer. The contact received notification of NHTSA Campaign Number: 23V342000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The local dealer was contacted and determined that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA ODI 11548400

The contact owns a 2022 Ford Explorer. The contact received notification of NHTSA Campaign Number: 23V342000 (Back Over Prevention) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

NHTSA ODI 11546862

The contact owns a 2022 Ford Explorer. The contact stated that while reversing, the backup camera was slow to respond. The screen displayed an image of the vehicle. Additionally, there was an extreme amount of air entering the vehicle from the door seals. There were no warning lights illuminated. The vehicle was taken to the local dealer, who was unable to duplicate the failure, but the vehicle was not diagnosed or repaired. The dealer referred the contact to the manufacturer. The manufacturer was notified of the failure and referred her to the NHTSA Hotline. The failure mileage was approximately 5,100.

NHTSA ODI 11536551

When going from Drive to Reverse, the car will delay for 30 seconds to a minute and display a white vehicle screen. It will be inoperable during this delay time, which can be dangerous given the situation and I have almost been hit twice because of this delay. I am uncomfortable driving the vehicle, as not being able to put the car immediately into reverse in any given situation is dangerous for both myself, my children and anyone else on the road. The vehicle has been into the dealership, they said no issue exist. However, after picking up the vehicle the concern still exist and now I am stuck with a vehicle that I cannot drive. No warning messages are being displayed, this is one reason why the dealership is saying there is no issue.

NHTSA ODI 11533334

The contact owns a 2022 Ford Explorer. The contact stated that while reversing, the vehicle was shaking and slow to respond. The contact stated that the back over prevention camera screen was gray while the vehicle was rolling backwards. The contact stated that the back over prevention camera screen then turned blue. There were no warning lights illuminated. The contact called the local dealer, but the vehicle was not diagnosed or repaired due to a scheduling issue. The manufacturer was contacted and referred the contact back to the dealer. The failure mileage was approximately 18,000.

NHTSA ODI 11529586

I was backing up at low speed (less than 1 mph) to park by gently letting my foot off the brake to back. I was using the rear backup camera to gauge how far I could go back without striking the vehicle behind me. The screen showed video that I was still several feet away from the vehicle behind me when I felt a sudden bump. I stepped on the brake hard to ensure I was no longer moving but the camera still showed several feet between my rear bumper and the vehicle behind me. I put the vehicle in park and got out to verify that I had struck the vehicle behind me. I had. I returned to the driver’s seat, put the vehicle back in reverse to see what the camera showed and now it appeared on the screen that my bumper was touching the vehicle behind me. The video on the screen had absolutely froze while I was backing, which contributed to me making an error in judgement while backing, causing me to strike the vehicle behind me. The DuPage County Sheriff’s Office (Illinois) completed a crash report. SOPC23-08519

NHTSA ODI 11529002

The contact owns a 2022 Ford Explorer. The contact received notification of NHTSA Campaign Number 23V022000 (Back Over Prevention) however, the part to do the recall repair was unavailable. The local dealer was contacted, and it was confirmed that the part was not available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool showed no information of the recall.

NHTSA ODI 11525780

The contact owns a 2022 Ford Explorer. The contact received notification of NHTSA Campaign Number: 23V022000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated while driving 15 MPH, the vehicle hesitated while accelerating and lost motive power. No warning light was illuminated. Additionally, the rearview camera was inoperable while reversing. The contact stated that the front driver's side seat inadvertently moved towards the steering wheel while driving. The headlights inadvertently turned off while driving at night. The contact stated that the transmission also failed to shift into gear. The vehicle was towed to the dealer, where it was diagnosed with unknown electrical failures due to faulty programming. The dealer confirmed that parts were not available to perform the recall repair. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was 1,800. VIN tool confirms parts not available.

NHTSA ODI 11524468

Vehicle is as purchases brand new in august 2022. After a few months when engaging reverse, there is a lag time of 3-10 seconds. The reverse screen in dash does not engage as well. Local dealer “fixed” in February 2023 at roughly 5k miles. Issue has returned. When brought to dealer beginning of May 2023. We were informed they would not work on it as it’s a known issue with no fix. Issue is creating problems when attempting parallel parks, k-turns, parking, anything to do in the road requiring timliness and safe execution of parking. When vehicle has the lag time it is not in gear and wil roll if on an incline.

NHTSA ODI 11523071

In late October, 2022, when reversing in my driveway, I hit a tree. The rear camera alert system did not notify me of the presence / closeness of the tree (lived here almost 6 years, should know of tree but heavily rely on the camera and alerts to let me know if I'm too close). On another day, my husband was in the car with me and as I was reversing - he said "your alert didn't go off, this is probably why you hit that tree." I was unaware until today (1/30) that there is an active recall on my car for this issue. I had the damage fixed in November at Gerber Collision Center in Sebastian FL (Micco Rd). The cost of the fix was $2046 out of pocket (did not claim through insurance). Rear-driver side lamp, bumper, quarter panel. Invoice for repairs is included for detail in what all needed to be fixed. Pictures are not great and are after we taped the light on.

NHTSA ODI 11504384

APIM Module failure at 148 miles on a brand new 2022 Explorer XLT. SYNC display went black. No response to touch. No warning lamps or alerts. Radio still plays and can be controlled by steering wheel controls. Contacted dealer and they said to disconnect negative battery terminal for more than 30 minutes. Performed requested action. Display is still dark. No reverse camera or safety (ADAS) functions. Took it to dealer again and they ran diagnostics to determine APIM module failure. So now I have a brand new Explorer with reduced safety features and no center console display. I cannot control any ADAS or radio features. Dealer has no estimated timeline for repair. Dealer also stated that they are getting APIM module failures DAILY.

NHTSA ODI 11480875

The contact owns a 2022 Ford Explorer. The contact stated while driving at various speeds, the Forward Collision Avoidance system activated without incident. The contact also stated that the Back Over Prevention camera would display several errors while in use. Additionally, the thermostat would indicate the wrong vehicle temperature causing the engine hot warning message to appear on the instrument panel. The thermostat and the Back Over Prevention camera sensors were both replaced. The Forward Collision Avoidance sensors were also replaced; however, the failure returned a month after repair. The manufacturer had been notified of the failure. The vehicle had yet to be repaired. The failure mileage was 7,700.

NHTSA ODI 11480604