The contact owns a 2024 Jeep Wrangler. The contact stated that when attempting to accelerate from being idle, or while driving at various speeds, the vehicle would suddenly jerk, accelerate at an unexpected speed, or fail to accelerate. There was a ticking noise coming from the front end of the vehicle that could be heard when standing outside the vehicle. The Check Engine light and the explanation warning light, as well as others not specified, would illuminate intermittently. The vehicle was taken to the dealer several times; however, the dealer was not able to diagnose the failure. The dealer updated the vehicle's software but was unable to provide a remedy for the failures. The dealer informed the contact of NHTSA Campaign Numbers: 25V741000 (Electrical System) and 25V766000 (Engine); however, the parts to do the recall repair were unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. While driving approximately 25 MPH, after accelerating from being idle at a stop light, the vehicle suddenly jerked and stopped. The contact pressed the accelerator pedal, and when doing so, the vehicle accelerated at a high speed, immediately causing the contact to lose control of the vehicle. The vehicle ended up crashing into a fire hydrant, causing it to stop. The air bags did not deploy. The contact received injuries to their shoulders, lower back, neck, and left knee. Medical attention was needed. A police report had been filed. The vehicle was towed from the incident. The contact stated that while the police were there, the officer noticed the engine revving as if the accelerator pedal was being pressed; however, the pedal was not pressed at the time. The manufacturer was made aware of the issue, and a case was opened. The contact had not heard from the failure. The contact had not experienced a failure mileage was unknown.
NHTSA ODI 11713837