My wife was going at about 10 - 15 mph coming up about 2 car lengths to a small curve in a residential area when all of a sudden she heard a pop or snap and the Rav4 went to a super high speed by itself. The acceleration could not be stopped even though she had her feet on the brakes. She had both hands on the steering wheel to avoid hitting a house and ended up going through a wall in the yard. There were no warning sounds and no signals indicating a problem. it appeared that the display was blank. There was no pre-collision warning or braking except as my wife was pushing on the brakes. She also hit the right side into side wall. No air bags deployed even though Windshield and all door glass on sides shattered. My wife the driver was okay and not hurt, and the grandchild in the car seat behind my wife was fine also. Neither had injuries. There were checked by emt. The police looked but all would not try to get in except to remove my granddaughter. My wife was removed also because she could not get out the door was jammed against shed and rock, and handles broken off This happened after the recall work was done by toyota dealer on 12/04/2025. There were no problems prior to the recall. I've listed the recall below. 25TD01 Rear Traction Motor Cable Corrosion - Multiple Model & Model Year Toyota Hybrid (AWD) Vehicles NHTSA Recall ID AWAITING# Recall Date Dealer Reference ID 25TD01 Description The subject vehicles are equipped with a rear motor unit and an HV Floor Under Wire that provide high voltage to operate the motor. Mud, water, or road salt could potentially enter the HV Floor Underwire connector housing and could cause corrosion over time. Excessive corrosion could cause AM Radio Static during certain driving cycles, or the vehicle may not start. Status Remedy Available Remedy Any authorized Toyota dealer will apply a wire harness protector seal to the HV Floor Under Wire Connector. Toyota corporate engagement is looking into this.
NHTSA ODI 11706225