Immediately after purchasing the vehicle, I got error codes thrown to service the suspension while driving to my house, specifically at 15-20mph over traffic calming bumps. This fault cleared immediately the first few times. On July 25 I submitted a service request as my family headed out on a two week, 900 mile trip. The service suspension fault had returned and disabled my ability to change modes/ride heights, blind spot sensors and cruise control, all of which I was counting on using during trip. I shut off and restarted the vehicle several times trying to clear the fault and regain functionality, but the fault inevitably returned. On July 25, Rivian added a response in the service portal that they would address the problem by July 28th. I heard nothing more. On August 1, I was driving south on HWY 57 in North Idaho. I hoped that code would have cleared, but it came back on almost immediately. After driving for about 5 miles, I decided to pull over at a visitor center parking lot to try and reset again to change modes, regain safety sensors, and cruise control. While turning left into the parking lot, another driver tried to pass on my left on a double yellow line driving above the 55mph speed limit. He collided with the front left part of my vehicle, damaging the body and breaking the front tie rod ends, leaving me unable to steer or drive forward, disabled, in the oncoming traffic lane. I asked Rivian to share data about the turn signal use, brake light, and speed data at the time of the accident with me. They did not respond in writing, but called and refused, getting quite angry during the call. After researching and observing other Rivians, I don't believe that my brake lights were on during regenerative braking. The rear, side, and blind spot sensors were disabled. Turning 1/4 second sooner or 5º sharper would have killed me.
NHTSA ODI 11550710