What 36 owners told NHTSA about the 2012 Mitsubishi Outlander Mhev

TL* THE CONTACT OWNS A 2012 MITSUBISHI OUTLANDER. THE CONTACT RECEIVED NOTIFICATION OF NHTSA CAMPAIGN NUMBER: 16V791000 (VISIBILITY) AND STATED THAT THE PART WAS NOT AVAILABLE WITHIN A REASONABLE TIME FRAME TO SCHEDULE THE RECALL REPAIR. THE DEALER (LARRY JAY MITSUBISHI, 8415 SOUTH BLVD, CHARLOTTE, NC 28273, (866) 237-9670) DID NOT GIVE A SPECIFIC DATE FOR WHEN THE PART WOULD BECOME AVAILABLE. THE MANUFACTURER COULD NOT PROVIDE AN ESTIMATED DATE FOR WHEN THE CONTACT'S VEHICLE WOULD RECEIVE THE RECALL REPAIR. THE CONTACT WAS NOT EXPERIENCING A FAILURE. VIN TOOL CONFIRMS PARTS NOT AVAILABLE.

NHTSA ODI 11006722

I HAVE A RECALL # 16V791, AND NOTHING HAPPEN FOR FIX THE PROBLEM

NHTSA ODI 10980029

TL* THE CONTACT OWNS A 2012 MITSUBISHI OUTLANDER. THE CONTACT RECEIVED NOTIFICATION OF NHTSA CAMPAIGN NUMBER: 16V791000 (VISIBILITY); HOWEVER, THE PART TO DO THE REPAIR WAS UNAVAILABLE. THE CONTACT STATED THAT THE MANUFACTURER EXCEEDED A REASONABLE AMOUNT OF TIME FOR THE RECALL REPAIR. THE MANUFACTURER WAS NOT MADE AWARE OF THE ISSUE. THE VIN WAS UNKNOWN. THE CONTACT HAD NOT EXPERIENCED A FAILURE.

NHTSA ODI 10959748

I DONT FIND ANY CUSTOMER SERVICE FOR MY RECALL FOR THE BODY PIECE BETWEEN THE HOOD AND WINDSHIELD MITSUBISHI OUTLANDER

NHTSA ODI 10956653

TAKATA RECALL WHEN DRIVING MY VEHICLE MAKES A WINING SOUND FROM THE ENGINE IN THE VEHICLE WHEN I AM DRIVING. SECOND PROBLEM IS THE MY WINDHIELD WIPER NO LONGER HOLD WATER AND IT IS LEAKING OUT COMPLETELY. THE WINDSHIELD WIPER WORKED WHEN PURCHASED AND THE ENGINE LOUD WINING NOISE JUST STARTED IN SEPTEMBER WHEN THE WINDSHIELD STOP WORKING. THE ENGINE NOISE IS WHILE BEING DRIVEN. THE WIPER JUST STARTED LEAKING IT HAS A HOLD IN THE RESERVER I BELIEVE.

NHTSA ODI 10925524

ONE DAY I NOTICED A SCREW MISSING FROM THE PIECE THAT HOLDS THE VISOR TO THE ROOF AND IT WON'T BE LONG UNTIL THE VISOR FALLS ALL TOGETHER. *JS

NHTSA ODI 10579398

WHILE IN MOTION, AN ANCHORING SCREW HOLD THE PASSENGER SIDE VISOR TO THE ROOF PANEL FELL OUT INTO MY LAP. AS THE PASSENGER AT THE TIE, I CHECKED THE VISOR, NOTICING THE SCREW FELL FROM ABOVE AND NOTICED THE SECOND OF THE TWO ANCHORING SCREWS WAS NEAR FALLING OUT, ALSO. PREVIOUSLY, A SIMILAR SCREW HAD BEEN FOUND ON THE DRIVER'S SIDE FLOOR AREA, BUT THE LOCATION IT CAME FROM WAS NOT APPARENT AS THE VISOR MOUNT FROM WHICH IT FELL WAS HIDDEN BY THE POSITION OF THE DRIVER SIDE VISOR. CHECKING THE DRIVER SIDE VISOR, I NOTICED THE SECOND AND LAST ANCHOR SCREW WAS ALSO VERY LOOSE AND MOSTLY OUT OF THE TIGHTENING POSITION IT SHOULD HAVE BEEN IN. I ENVISION THAT IN A CIRCUMSTANCE WHERE AN AVERAGE DRIVER DID NOT NOTICE THE ANCHOR SCREWS WERE LOOSE FROM THE VISOR MOUNT OVERHEAD, THE VISOR COULD FALL ONTO THE STEERING WHEEL OF THE VEHICLE POSSIBLY CAUSING INABILITY TO STEER THE VEHICLE OR SURPRISING THE DRIVE ENOUGH TO CAUSE LOSS OF CONTROL OF THE VEHICLE. IT APPEARS THE TORQUE ON THE SCREWS WAS INCORRECT TO KEEP THEM SECURED, OR THE THREAD OF THE SCREW IS NOT CORRECT TO HOLD THEM TIGHT INTO THE VISOR MOUNTS, ALLOWING VIBRATIONS DURING NORMAL DRIVING USE TO ALLOW THE SCREWS TO BECOME LOOSE AND EVENTUALLY FALL OUT OF THE VISOR MOUNT BRACKET ALTOGETHER. I RESEATED THE SCREWS USING A SILICONE BASED GASKET SEALER TO PREVENT THE SCREWS FROM VIBRATING OUT OF THE BRACKET MOUNTS. HOWEVER, I CAN ENVISION THE SITUATION TO BE ONE THAT COULD CONTRIBUTE TO A CRASH. *TR

NHTSA ODI 10508705